Keri-systems TAP100 Bedienungsanleitung PDF herunterladen (Seite 33)

TAP100 Application Software Manual

Revision 3.3 Page 33

Configure the Readers

In this section we will the instructions for entering all the information required to create a reader

database for day-to-day operation. We will also look at commands for adding a new reader to an

existing database and at commands for globally securing the readers.

Figure 5 - Readers Menu Option Screen

Opening the Reader Database

The open reader database command, allows you to define all the day-to-day operating

parameters for each reader. Use your pointing device and select

eaders and then

pen readers

database. The following prompt box will appear.

The easiest way to describe the reader assignment process is through an example. In this

example, we will define reader 4 as an employees only entry/exit door with two reader antennas.

One of these reader antennas will be used to allow/monitor entrances, the other to allow/monitor

egresses.

Use your pointing device and select the reader in which you want to set values – in this case,

reader 4. The reader will be identified by a bright highlight bar. Use your pointing device and

TAP100 - Keri Systems, Inc.

Cards Transactions Readers Utilities Setup Info Quit

READERS

OPEN UNLOCK ALU SUP ALARM

RDR NAME (Ant A) TIME TIME ZONES APB I/O CTRL POL

2 no name 1-A 20s 5s 7 7 N N Y N/C

3 no name 1-A 20s 5s 7 7 N N Y N/C

4 no name 1-A 20s 5s 7 7 N N Y N/C

5 no name 1-A 20s 5s 7 7 N N Y N/C

• • •

Press a hot key to make a selection.

1 no name 1-A 20s 5s 7 7 N N Y N/C

Open reader database

Query status of a reader

Lock a reader

Unlock a reader

Install new reader

Enable global lock/unlock

Disable global lock/unlock

Global secure

MODIFY PRINT SEND QUIT

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 83 84

Keine Kommentare

Keri-systems TAP100 Bedienungsanleitung Seite 33